岩石（煤）的碎胀与压实特性研究

本文通过自行设计的一套岩石（煤）的松散和压实试验方案及相应的实验设备，对兖州矿区岩（煤）样进行了较为系统的碎胀与压实特性研究，测定了岩石（煤）的碎胀系数、碎胀曲线、压实曲线和侧压曲线．     

Liquid single- and gas—liquid two-phase flows of magnetic fluid in the presence of a high non-uniform parallel magnetic field

The effect of a non-uniform parallel high magnetic field on flow control characteristics is investigated experimentally for a magnetic fluid single-phase flow and an air—magnetic fluid two-phase flow in a vertical channel. It is found that as the magnetic field strength is increased, the friction factor of the single-phase flow increases significantly. For the two-phase flow, the friction pressure loss and the head pressure loss, which is smaller than the friction loss, are negligibly small compared with the magnetic pressure loss. In the case where air is injected 27.9d upstream from the maximum magnetic field, the air flow is blocked by the magnetic force in the entrance of the magnetic field, which leads to increases in both local void fraction and pressure drop there. In the case where air is injected 1.43d downstream from the maximum magnetic field, the air flow is accelerated, resulting in a decrease in void fraction and an increase in pressure rise. In the latter case and under the present range of experimental conditions, the magnetic pumping head reaches 0.02 MPa at the highest, and the maximum circulation flow rate reaches twice as high as non-magnetically driven flow rate.     

软粘土卸载特性计算模型研究

本文从三个方面对软粘土的卸载特性进行了理论研究。采用太沙基一维固结理论，编制了内嵌固结计算的修正剑桥模型程序．对软粘土卸载强度进行了分析。推导了基于修正剑桥模型的孔压表达式并编制了相应的程序对软粘土的卸载孔压特性进行了研究，结果显示，在伸长条件下．孔压先由零逐渐发展到负的最大值．然后又逐渐减小至零。突破零位后，发展成为正孔压并最后达到正的最大值。围压越大，产生的负孔压的极值越大，最终的正孔压越小。将传统边界面模型的线弹性卸载过程改进为弹塑性．建立了软粘土的边界面广义弹塑性模型，从而使边界面模型可用于分析软粘土卸载过程中的塑性变形问题。理论分析结果与试验进行了比较验证，证明理论研究方法是可行的。     

The Development of Appropriate Upscaling Procedures

Permeability upscaling should be carried out with careful attention to the nature of rock heterogeneities. While there are many large-scale features which must be taken into account, there are also important heterogeneities at the small-scale. Many sedimentary structures contain laminae at the mm–cm scale, and beds at the m-scale, which give rise to strong contrasts in permeability. We use a 2D model derived from a photo-panel of an aeolian outcrop, along with permeability measurements from a North Sea oil field, to demonstrate the effects of small-scale heterogeneity. This model is similar in size to a typical cell of a reservoir geological model. We take imaginary probe and core plug measurements from the model, average them, and compare these with the effective permeability for the model computed from a finite difference flow calculation. Although this procedure is standard practice, we show that it can lead to biased estimates of the permeabilities used in flow simulation. As an alternative we suggest using models of representative beds, and performing flow simulation to calculate effective permeabilities for both single-phase and two-phase flow.     

多功能Hopkinson压杆型试验装置的研制与应用

对传统的Hopkinson压杆试验装置进行了改进和完善，除了用于材料的动态压缩以外，还能进行动态拉伸、绝热剪切、裂纹扩展速度测定、动态断裂韧性测试等．本文介绍了几种试验方法的基本原理，并给出了试验结果．     

金—稀土合金电刷丝的磨损机理研究

采用扫描电子显微镜、微区电子探针及 X射线光电子能谱等分析测试技术考察了金 -稀土合金电刷丝摩擦副的磨损机理 .结果表明 :该摩擦副的摩擦磨损机理为轻微粘着磨损 ;合金中稀土元素发生偏聚 ;在摩擦升温过程中 ,稀土元素向合金表面扩散富集 ,摩擦副接触表面氧化层不断生成和磨损 ,从而降低电刷丝的表面能 ,使摩擦副的接触表面粘着能降低 ,从而改善其摩擦磨损     

The effect of magnetic field on two-phase liquid metal flow

In this paper, the basic equations of two-phase liquid metal flow in a magnetic field are derived, and specifically, two-phase liquid metal MHD flow in a rectangular channel is studied, and the expressions of velocity distribution of liquid and gas phases and the ratioK ₀ of the pressure drop in two-phase MHD flow to that in single-phase are derived. Results of calculation show that the ratioK ₀ is smaller than unity and decreases with increasing void fraction and Hartmann number because the effective electrical conductivity in the two-phase case decreases. The Project is supported by the National Natural Science Foundation of China.     

本征正交分解技术在屋盖风压场重建与预测中的应用

给出利用本征正交分解(POD)对屋盖风压场进行重建和预测的研究结果.对一个双坡屋盖用同步多点压力扫描系统进行了风洞试验,根据POD技术采用前若干阶本征模态重建屋盖风压场.采用两种方案预测未布置测压点位置的风压时间序列.第一种方案中利用插值技术获得没有测压点位置的本征模态值.第二种方案对参考屋盖和需预测的新屋盖分别进行试验,结合由参考屋盖试验萃取的本征模态和由新屋盖试验的风压数据计算的主坐标,预测出新屋盖未知区域的风压时间序列.文中对风压场重建和预测的效果作了分析,而且比较了根据测量的风压数据和预测的风压数据所计算的屋盖风致响应.     

高压下受限齿轮油成膜特性研究

本文揭示了在实际应用中极端工况下齿轮油的润滑特性.为了测量在高接触压力和不同温度条件下齿轮油的成膜能力,制作了高精度的膜厚测量仪,采用相对光强法实现纳米级膜厚测量.试验中共采用了5种性质不同的齿轮油,在纯滚动条件下测量接触区的油膜厚度,结果表明：随着接触压力的升高油膜厚度明显降低,但压力对润滑状态影响不大;温度的改变不但能影响油膜厚度,对润滑状态的影响也很明显;GL-5 85W/190和GL-5 85W/90齿轮油在接触压力达3 GPa温度提高到120℃时仍能形成很厚的油膜,但其余3种润滑剂在极端工况下成膜能力不足.本文最后根据试验结果还提出了含有丰富添加剂的齿轮油润滑模型.